Tips To Keep The Household Warm During Winter

This winter has been one of the harshest in many years. Heating systems across the country are in full throttle to fight the cold. The harder they work, the greater the chance of failure. It would be quite troublesome for the gas furnace to give out in the middle of a chilly night. Be proactive in taking care of them to minimize the risk of damage. Learn more about the common issues that plague these systems as well as the strategies that can be used to prevent their occurrence.

Clogging is one of the most frequent triggers of heating system malfunction. This can happen in several areas including the air filters and flue pipes. The filters are naturally prone to dirt as it is their job to block these off to maintain good air quality within the system. Over time, the dust and dirt accumulates to a level that causes air flow problems. This can happen slowly if they are isolated in a fairly clean room or fast if there are nearby sources of dust and debris. The only way to know for sure is to check on the filters once in a while. They should be replaced as often as necessary.

Flue pipes, on the other hand, tend to be exposed to debris such as leaves, twigs, and snow drifts. Birds may find them convenient places for nesting and leave things that will block off the openings. These will have to be cleared off at the soonest possible time so that the system doesn’t suffocate from the lack of air. If homeowners suspect deterioration in heating performance, then the pipes should be inspected and cleaned thoroughly.

The thermostat setting should also be given some thought. Pipes are often vulnerable to the extreme outside temperatures because they are situated on the external walls. If the system is not generating enough heat, then the pipes might suddenly burst. This is because ice is less dense than water. The freezing temperatures will cause an expansion. Therefore, it is prudent for people to increase the setting to compensate for the cold. Just a few degrees will go a long way towards keep the pipes intact and the household warm.

Lastly, homeowners must pay attention to the boiler pressure. The water should not exert anything lower than 12 pounds per square inch or anything higher than 15 pounds per square inch. This is the optimal range for the system and going beyond them is a sure sign of trouble. If an anomaly is detected, then the heating contractor should be notified immediately of the situation. A licensed and certified technician from Ideal Comfort of Cucamonga, CA may be sent to verify the observation, locate the source of the problem, and make the appropriate adjustments.